|
Instructions:
Remove one side of the backing from the
double-sided tape and attach it to the flat side of the trigger
element. Remove the other side of the backing and attach the trigger
element to the drumhead about ¾” from the rim near a tuning lug.
Attach the ¼” jack to the drum by using the
mounting clip or Velcro tape.
Using the mounting clip: remove a tension screw
at the desired mounting point, place the ¼” jack into the clip and
mount it to the drum lug by inserting the tension screw through the
clip and rim. Then tighten as needed.
Using Velcro tape: remove one side of the
adhesive backing and attach it to the ¼” jack. Remove the other side
of the adhesive backing, attach it to the drum shell or rim at a
convenient location and press the Velcro halves together.
Connect the drum trigger to your drum module and
properly adjust the module’s parameters (sensitivity, gain, threshold,
noise, etc.) and volume.
|
